Heater Band Heater Control Request for Quote Form (NOT for "Cast-ins")
Company Name: * Contact Name: *
Phone Number: * E-mail Address: *
Address: City:   State:   Zip:
* Required
A PICTURE IS WORTH A THOUSAND WORDS
Whenever possible, a picture of the existing heater or the area of the application is always extremely helpful.
This form can be used for round bands only. For any special shape, please contact us directly.

Type Of Band Heater:
HT (High Temp Mica)
Quantity Needed: Units of Measure: Inches MM
Diameter:
If you measure the circumference - YOU MUST CALL US DIRECTLY.
*** If the band is a "Partial Coverage" (any less than "all the way around" - Please contact us directly. 		Heater ID Barrel OD Width: (½" increments only)
Wattage: Voltage:
Dual Voltage: Yes No


Three-Phase: Yes No
Construction Style:
Choose 		Clamping Variations:
Choose
Lead Type: (Termination)
Choose 		Lead Location: (instructions)
(degrees from Gap)
Lead Wire Length: Armor Cable/Braid Length:
(if applicable)
Typically 2" less than the lead length
Ground Wire: Yes No Plug on Lead-End: Yes No
Holes: Yes No
Notch/Cut-Out: Yes No
Special Gap: Yes No
Other Special Features:
Comments/Questions/Etc.:
QUESTIONS??? Please feel free to contact us directly
Main Office Line
952-988-8562
sales@beesindustrial.com 		Bonnie Stein
612-991-2553
bstein@beesindustrial.com 		Brian Nichols
612-812-7025
bnichols@beesindustrial.com 		Jacob Stein
612-840-1207
jstein@beesindustrial.com